Soldering iron with ceramic heater Tip - cone with a 0.4 mm end, durable, chrome-plated.
5-pin connector, i.e. soldering iron without motion sensor.
It can also be used with soldering stations of other manufacturers, designed to work with a soldering iron with a HAKKO 1321 heater.
Soldering iron with ceramic HAKKO1321, built-in resistive-type temperature sensor, supply voltage 24V, power 60-75 W.
Sting - cone with an end face of 0.4 mm, durable, chrome-plated.
Heater made of conductive ceramic with built-in resistance-type temperature sensor. Such a heater, in comparison with nichrome, at the same rated power, has better heating dynamics, the temperature is measured more accurately and is more durable.
Heater parameters: in a working element, the resistance between the heater terminals is about 3-4 Ohms, the resistance between the terminals of the temperature sensor is about 50-60 Ohms.
It is also possible to use with similar soldering stations from other manufacturers, designed to work with a soldering iron equipped with a HAKKO1321 heater, i.e. with a thermistor as a temperature sensor. You only need to replace the connector.
For example, this soldering iron is suitable for Lukey-868 and Lukey-852D+stations, if you change
connector or connect via < a href = "http://voron.ua/en/catalog/024842" target = "_blank"> adapter .
To connect the soldering iron to non-original control units (home-made or from other manufacturers), you can use the following mating connector parts:
for installation on the device body 
The data presented in the product description are for reference only and may differ from those indicated by the manufacturer.
