The CD4026 drives 7-segment displays. It also has a built-in decade counter.
The counter increments each time the «clock» pin goes HIGH (on the rising edge). Outputs a-g go HIGH according to the counter value and display it as a digit on a 7-segment common-cathode display.
The «reset» pin should normally be tied to ground. When it goes HIGH, the counter resets to zero.
The «disable clock» pin should also normally be tied to ground. While it is HIGH, signals on the «clock» pin are ignored.
The «enable display» pin must be tied to the supply voltage, otherwise outputs a-g are LOW. The «enable out» pin repeats its value with a small delay.
The «÷10» pin (h in the table) is HIGH for values 0-4 and LOW for 5-9. Its output can be fed to the «clock» input of the next 7-segment driver to build a multi-digit counter.
The «not 2» pin is LOW if and only if the counter value is 2. Otherwise it is HIGH.
Only registered users can leave feedback and ask questions
The data presented in the product description are for reference only and may differ from those indicated by the manufacturer.
To carry out technical calculations and obtain the exact parameters of the goods, use the datasheets from the manufacturer's website.
If you need additional information, or you found an error in the description, or have other questions about this product, then our manager will help you: Евгений ЗП
unknown