For soldering irons with temperature control.
Ceramic heating element with a built-in thermistor as the temperature sensor.
It is PTC ceramic, not a nichrome coil in a ceramic shell!
Rated supply voltage - 220V.
Rated power - 110 W.
The heater is designed to operate only in temperature-controlled soldering irons, in pulse mode!
Heat-up is very fast, and continuous power supply will quickly overheat the heater and cause it to fail.
With properly tuned PID temperature control, this heater tolerates exceeding its rated power well, but watch the quality of the tips used. Cheap tips with lower thermal conductivity or wrong mounting dimensions greatly shorten the heating element's life.
The key difference of this heating element is the resistive temperature sensor. It must not be replaced with a similar heater with a nichrome coil and thermocouple!
To avoid confusion, pay attention to the external distinguishing features of the original heater:
-
there is a longitudinal groove along the heater formed in manufacturing;
-
the outer end of the heater is a flat disc slightly smaller in diameter than the heater itself, like a step (on nichrome heaters the end cap is mushroom-shaped or just sealed with ceramic paste, and sometimes falls out).
In a good element, the resistance between the heater leads is about 200-220 Ohm, and between the sensor leads about 50-60 Ohm.
Specifications:
-
supply voltage: 220 V
-
rated power: 110 W
-
diameter: 3.8 mm
-
rod length: 60 mm
-
mounting length (with leads) : 70 mm
Packaging: plastic vial (protects against damage in transit).
All heating elements are tested before sale - visual inspection and checking heater and sensor resistance.
The warranty does not cover heating elements.