PLASTIK varnish based on acrylic resins.
Forms a shiny elastic protective layer that resists acids, salts, mold, corrosive fumes, alcohols, thermal and mechanical influences, alkalis, moisture and other manifestations of an aggressive environment. The coating remains effective over a wide temperature range from –70°C to+120°C. Forms a stable film on metals, plastics, wood, glass, etc. Does not drain and allows soldering through the protective layer.
Does not require removal during repair soldering (it will peel off in contact with the hot tip of the soldering iron).
Packing: 5 liters in a tin can.
Characteristics
-
color: colorless
-
density: 0.88 g/cm³
-
drying time at room temperature: after 25 min. dries until it comes off, dries completely after 48 hours
-
oven drying time: 2-4 hours at 60-70°С (after preliminary drying at room temperature for 10-15 minutes)
-
minimum layer thickness: 20-50 μm
-
consumption (average): 10-20m²/l
-
operating temperature range: -70°С -+120°С
-
viscosity: 12c (DIN 53211)
-
resistance to: acids, salts, corrosive fumes, alcohols, thermal and mechanical influences, alkalis, moisture
-
surface resistance 5 × 10 14Ω
-
insulation resistance: 10 14Ω
-
dielectric strength: 21 kV/mm
Purpose
Protection of printed circuit boards, components, transformer windings and electric motors etc.
Elimination and prevention of current leakage, corona discharges, short circuits, charge leakage.
Protection against corrosion of components exposed to negative influence of atmospheric conditions.
Protection against moisture of various materials, such as cardboard, wood, leather, etc.
Recommended use
Spray, brush or dip application.
If necessary, adjust the viscosity with original solvent
Thinner Plastik.
The use of a non-original solvent leads to unpredictable changes in the properties and quality of the coating!
The surface to be protected must be free from dirt and grease. Apply the aerosol by spraying from a distance of approximately 30 cm, otherwise drips may form on the surface. The clogged nozzle is washed with a solvent, acetone or turpentine.
When applying by spraying or brushing, it is recommended to cover 2-3 coats with obligatory interlayer drying for about 30 minutes.