PLASTIK varnish based on acrylic resins.
Forms a glossy elastic protective layer resistant to acids, salts, mold, corrosive vapors, alcohols, thermal and mechanical stress, alkalis, moisture and other aggressive environments. The coating remains effective over a wide temperature range from –70°C to +120°C. Forms a durable film on metals, plastics, wood, glass, etc. Does not run and allows soldering through the protective layer.
Does not need to be removed for rework soldering (comes off on contact with a hot soldering iron tip).
Packaging: 1 liter in a tin can.
Specifications
-
color: colorless
-
density: 0.88 g/cm³
-
drying time at room temperature: tack-free in 25 min., fully dry in 48 hours
-
oven drying time: 2-4 h at 60-70°C (after pre-drying at room temperature for 10-15 min)
-
minimum layer thickness: 20-50 μm
-
consumption (average): 10-20m²/l
-
operating temperature range: -70°C - +120°C
-
viscosity: 12s (DIN 53211)
-
resistance to: acids, salts, corrosive vapors, alcohols, thermal and mechanical stress, alkalis, moisture
-
surface resistance 5×1014Ω
-
insulation resistance: 1014Ω
-
dielectric strength: 21 kV/mm
Purpose
Protection of printed circuit boards, components, transformer and electric motor windings, etc.
Elimination and prevention of current leakage, corona discharge, short circuits and charge leakage.
Corrosion protection of components exposed to adverse atmospheric conditions.
Moisture protection for various materials such as cardboard, wood, leather, etc.
Application guidelines
Applied by spraying, brushing or dipping.
If necessary, adjust the viscosity with the original thinner
Thinner Plastik.
Using a non-original thinner leads to unpredictable changes in the properties and quality of the coating!
Clean and degrease the surface first. Spray from about 30 cm, otherwise runs may form. Rinse a clogged nozzle with solvent, acetone or turpentine.
For spray or brush application, it is recommended to apply 2-3 coats, with mandatory drying of about 30 minutes between coats.