Digital current clamp for non-contact measurement of alternating current (AC ) up to 1000 Amperes. Multimeter functions. Manual selection of measurement limits.
This model of current clamp allows you to measure the value of the alternating current (AC) by a non-contact method, and also measure AC and DC voltage, AC current, resistance, allow you to ring the circuit for an open circuit in the multimeter mode , using the measuring probes.
The "Data Hold" function makes it possible to carry out non-contact current measurements in hard-to-reach places where it is difficult to visually check the display readings.
Measuring functions:
AC
AC and DC voltage
chain ringing (with sound signal)
Data Hold
low battery indication
SPECIFICATIONS:
display: LCD 3 1/2 digit (1999)
sampling rate: 3 times/s
display backlight
constant voltage (DC): 1000V, error ±(0.5%+1)
alternating voltage (AC): 750V/1000V, error ±(1%+4)
alternating current (AC): 20A/1000A, accuracy ±(2.5%+5)
resistance: 200Ω/2kΩ, error ±(1%+1)
Continuity: beep at <50 Ohm
maximum measured wire diameter: 40 mm
power supply: 1pc battery 9V 6F22 "Krona"
dimensions: 242x80x44mm
weight: 480 grams
Accessories included:
set of test leads
Only registered users can leave feedback and ask questions
The data presented in the product description are for reference only and may differ from those indicated by the manufacturer.
To carry out technical calculations and obtain the exact parameters of the goods, use the datasheets from the manufacturer's website.
If you need additional information, or you found an error in the description, or have other questions about this product, then our manager will help you: Ярослав
unknown