Preheater for infrared heating of printed circuit boards from below when dismantling (assembling) electronic components.
An external thermal sensor (thermocouple) is attached to the board in the heating zone, providing feedback to the thermostat.
Temperature stabilization algorithm - PID controller.
Cooling fan in the heater platform.
Adjustable skids are provided for mounting the boards. The maximum width of the board installed in the holder is 135mm. The size of the heating zone is 120 mm * 120 mm. The length of the slide is 135 mm, but the board may protrude slightly from the slide.
If there is not enough width, you can lay the board directly on top of the sled.
The heating element is ceramic. Temperature controller with digital display and push-button control.
Specifications:
-
supply voltage: 220V, 50Hz
-
maximum power of the heating element: 600W
-
total power consumption of the pre-heater: 800 W
-
temperature adjustment range of the platform heating element - 0°С to 450°С
-
overall dimensions - 240 x 200 x 95 mm
Together with a hot air soldering station, the infrared preheater is quite affordable and quality equipment for repairing mobile phones, PDAs, digital cameras, computer boards, etc., and can also be successfully used for prototyping, in the development and manufacture of small batches of products.
Advantages of IR heating of PCBs over airflow:
-
lack of influence of air flow turbulence and, as a consequence, uniform heating of the board;
-
significantly larger heated area;
-
possibility of limiting the heating of individual sections of the board by shielding with reflective foil;
-
no noise and vibration from the blower.
Warranty for all models of soldering stations and board heaters is 3 months.
Heating elements and soldering iron tips are not covered by the warranty.
The data presented in the product description are for reference only and may differ from those indicated by the manufacturer.
