Overall dimensions: height 160 mm, diameter 93 mm.
To assemble the lamp you need:
Install the heatsink on the LED mounting plate using thermal paste, for example
http://voron.ua/catalog/027853with two screws.
Solder the connecting wires (red - plus and white - minus) to the mounting plate and connect the wires (of the same color) to the lamp base. Pre-pass the wires through the hole in the cardboard mug to isolate the driver from the radiator
The base can be glued to the lamp body, but it is best to use a core to make notches around the perimeter of the upper edge of the base, retreating 1.5-2 mm from the edge.
All mounting plates have been checked and in good condition. Test samples are collected and perform well.
The assembled lamp should not be used outdoors. moisture can get inside the case and damage the lamp.
Approximate schematic diagram:
Capacitor ratings: C1 = 1.8 μF/400 V; C2 = 10μF/250 V.
The data presented in the product description are for reference only and may differ from those indicated by the manufacturer.
