Upgraded version of the charger
SOROKA v.4-TOP .
In this model, a microcircuit of a quasi-resonant FSFA2100 converter and a synchronous rectifier in the low-voltage part are used in the power supply. This made it possible to raise the charger power to 450W and charge currents up to 30A, as well as to enable Users to apply three types of modulations for faster battery recovery after severe sulfation.
The charger can work with 2v, 4v (lithium) 6v (lead) 12v (lead) batteries and there are two user settings.
The changes concerned an increase in the reliability of operation in modes of high (15A-30A) currents, optimization of the microprogram code.
Benefits of using the SOROKA v.5-Profi charger:
-
reducing the cost of operating batteries
-
increase the battery life by 2-3 times,
-
recovery of sulphated batteries
-
prevention of premature aging of batteries
-
increased automation of battery charging processes;
-
increase in capacity and maximum output current of the battery
Storage capabilities:
-
charging highly discharged batteries with intermittent current
-
"Accelerated automatic adaptive charging" ("STD" and "AUTO" mode)
-
adaptive charging with additional capacity up to 100-105%
-
automatic desulfation (carried out in all modes)
-
automatic charging and discharging cycles (requires user to set discharge load)
The
manufacturer's website contains information on the method of maintenance and recovery of battery capacity, as well as theoretical foundations lead acid battery designs. Various modifications of batteries (gel, AGM) and the necessary requirements for the operation of different types of lead-acid batteries are described in detail.
In connection with possible hardware and software modifications of the device and the introduction of appropriate changes,
Operation manual not listed here on the current page.