Temperature controller LED display, easy to read.
The heating plate temperature is adjustable from 0°C to 200°C.
Temperature correction function: the surface area of the aluminum plate is relatively large, and its temperature may vary slightly with significant changes in ambient temperature. The temperature correction function compensates for this potential mismatch.
The built-in vacuum pump holds the display module against the plate; for this, a field of holes 70 x 40 mm with 10 mm pitch is formed in the plate surface. To ensure the vacuum, the preheater comes with a 170 x 100 mm silicone mat with the same hole field.
The plate surface is ground and matted for the best grip of the silicone mat, so that it does not shift under lateral force when pulling the cutting string.
Guide tubes, loosely fixed in supports, run along the long sides of the heating plate. Guide diameter 10 mm, polished stainless steel. The plane of the guides is slightly below the plane of the plate. They are used as supports for pulling the wire string during separation.
Technical data:
-
supply voltage: 220V + -10% 50 Hz
-
power consumption: 550W
-
built-in vacuum pump: 20 W
-
vacuum: 0.05 MPa
-
heater plate size: 190 x 110 mm
-
overall dimensions: 260 x 160 x 110 mm
The warranty for all models of soldering stations and board preheaters is 3 months.
The warranty does not cover heating elements and soldering tips, which are consumables.
_______________________________________
Repairing modern electronic designs, primarily portable mobile devices, requires special equipment, without which some repair operations simply cannot be performed properly.
Such operations include disassembling a display module (separating the glass), replacing chips in BGA packages, and working with components in ceramic packages and on ceramic PCBs. Ceramics are sensitive to the heating rate and to large temperature gradients of the working tool.
Using the currently most popular methods of desoldering components with a heated air stream (hot air gun) without bottom preheating of the board increases the risk of board warping due to local one-sided heating.
Preheating PCBs makes it possible to reduce the working temperature of the thermal tool, reducing the risk of damaging components by thermal shock.
The new board preheater models cover a wide range of repair work. This is due to the design of the heating plate - a ground aluminum surface.
The smooth aluminum heats the display module evenly.