The price of this item has been reduced due to scuffs on the aluminum handle housing that occurred during shipping.
The specified defect does not affect the functional properties of the product.
Reinforced engraving shaft.
Can be used not only with engraving tools but also with electric drills, machine tools and similar drives.
Shaft shank connection diameter 6 mm.
On the drive side, the shaft runs on a rolling bearing.
Shaft sheath - steel spiral, covered with flexible plastic.
Removable chuck handle in an aluminum housing.
The chuck shaft is also mounted in the housing on bearings.
Handle length 125 mm, diameter 25 mm.
The jaw chuck is tightened with a geared key (not included in this set)
Specifications:
-
shaft length: 0.9 m
-
rolling bearings: yes
-
handle length: 125 mm
-
handle diameter: 25 mm
-
chuck: jaw
-
clamped shank range: from 0.5 to 6.0 mm
-
material: aluminum, steel, plastic
Contents:
-
flexible shaft - 1 pcs
-
handle with chuck - 1 pc
-
chuck key - NOT INCLUDED!
Attention!
The shaft must be lubricated periodically during use.
Avoid sharp, small-radius bends of the shaft and operation at high speeds; this will extend the shaft's service life.