High-quality fast-acting remover for old paint coatings on smooth surfaces — metal, glass and some plastics. Removes oil, alkyd, acrylic, nitrocellulose, silicone and epoxy paints, primers, varnishes and thin powder coatings. Cleans off residues of old rubber seals and glue. One can covers 1.3-1.5 m².
Directions for use:
Aggressive product! Use a respirator, mask, goggles, protective clothing and rubber gloves.
-
Clean the surface of dirt
-
Protect surfaces you do not plan to strip with film or tape
-
Mix the contents by shaking the can for 1-2 min.
Shake the can periodically during use
-
Apply evenly from 10-15 cm and leave for 15-30 minutes until the old paint cracks or softens.
-
Remove the softened coating with a scraper.
For very resistant multilayer coatings, repeat the treatment.
Notes:
-
Before stripping paint from plastic surfaces, apply a small amount to make sure the product does not damage the plastic.
-
In hot and windy weather, cover the treated surface with plastic film to slow evaporation of the product.
-
On porous surfaces (wood, concrete, brick, etc.) the product may be much less effective.
Usage notes:
Extremely flammable aerosol. Pressurized container: may burst if heated. Causes serious eye and respiratory irritation and may cause drowsiness or dizziness. Toxic to aquatic life with long-lasting effects.
Keep out of reach of children. Keep away from heat, sparks, open flames and hot surfaces. Do not spray on an open flame or other ignition source. Do not pierce or burn, even after use. Use only outdoors or in a well-ventilated area. Seek medical advice if you feel unwell.
Protect from sunlight and store at temperatures not exceeding +50 °C. Optimal can and ambient temperature: from +15 to +25 °C.
Composition: Mixture of organic solvents, paraffin, propellant gas.