2 - red wire - VCC - positive supply. Do not connect to PWM controllers without an output filter.
3 - yellow wire - FG - open-collector output. It carries a square wave whose frequency is proportional to the rotation speed. A pull-up resistor is required on the controller side. Maximum current 10mA, maximum voltage 30V. If the impeller stops (stalls), the output may be either high or low. If not used, leave it unconnected.
4 - blue (gray) wire - PWM - speed control input. Signal type - 25kHz PWM with a duty cycle from 0% to 100%. It has an internal pull-up resistor to a 5V supply. Source current about 1mA. Requires an open-collector output on the controller side. Do not connect this input to +VCC, as it may damage the fan. If not used, leave it unconnected; the fan then runs at full power. Depending on the model, at a low signal level the fan either stops (in which case the 0% - 20% range is not recommended due to unstable operation at low speed) or runs at minimum power (then 0% corresponds to minimum power and 100% to maximum).
Only registered users can leave feedback and ask questions
The data presented in the product description are for reference only and may differ from those indicated by the manufacturer.
To carry out technical calculations and obtain the exact parameters of the goods, use the datasheets from the manufacturer's website.
If you need additional information, or you found an error in the description, or have other questions about this product, then our manager will help you: Евгений ЗП
unknown