Soldering iron with ceramic heater Tip - cone with an end face of 0.4 mm, durable, chrome-plated.
Connector with 6 pins, i.e. the soldering iron is equipped with a motion sensor. For those soldering stations that have a standby mode ("fall asleep" if the soldering iron lies in the stand without moving for some time).
A miniature ball switch is used as a motion sensor.
It is also possible to use it with soldering stations of other manufacturers, designed to work with a soldering iron with a HAKKO 1321 heater.
Soldering iron with ceramic HAKKO1321, built-in resistive-type temperature sensor, supply voltage 24V, power 60-75 W.
Sting - cone with an end face of 0.4 mm, durable, chrome-plated.
Heater made of conductive ceramic with built-in resistance-type temperature sensor. Such a heater, in comparison with nichrome, with an equal rated power, has better heating dynamics, the temperature is measured more accurately and is more durable.
Heater parameters: in a working element, the resistance between the heater terminals is about 3-4 Ohms, the resistance between the terminals of the temperature sensor is about 50-60 Ohms.
It is also possible to use with similar soldering stations from other manufacturers, designed to work with a soldering iron equipped with a HAKKO1321 heater, i.e. with a thermistor as a temperature sensor. You only need to replace the connector.
For example, this soldering iron will fit the Lukey-868 and Lukey-852D+stations if you change the connector. In this case, the motion sensor contact will be inactive.
Soldering iron accessories: