The XL2576T-ADJE1 is a buck DC/DC converter with output current up to 3A.
Wide input voltage range: from 4.5V to 40V
Adjustable output voltage: from 1.23V to 37V.
Fixed switching frequency: 52KHz.
The PWM control circuit can smoothly adjust the duty cycle from 0 to 100%.
Built-in overcurrent protection.
Built-in thermal protection.
The internal design of the IC allows a minimum of external components.
Has a low-current on/off pin.
Typical application:
To enable the IC, apply a logic low (below 0.8v) to pin 5 (ON/OFF); leaving the pin floating also enables it. Above 1.4V the IC shuts down.
The output voltage is set by a resistor divider; its values can be calculated with the formula under the typical application circuit.
Example: for an output voltage of 12V, with R1=1KOhm=1000Ohm R2=(Vout / 1.23 - 1) * R1=(12 / 1.23 - 1) * 1000 = 8756 Ohm = 8.756KOhm
In this case it is advisable to use a 10KOhm trimmer resistor.
Only registered users can leave feedback and ask questions
The data presented in the product description are for reference only and may differ from those indicated by the manufacturer.
To carry out technical calculations and obtain the exact parameters of the goods, use the datasheets from the manufacturer's website.
If you need additional information, or you found an error in the description, or have other questions about this product, then our manager will help you: Евгений ЗП
unknown