Electronic module Thermostat ХН-W1313

Изображение товара

Product description format_size zoom_out zoom_in

XH-W1313 high temperature digital thermostat module with K-type thermocouple is designed to control heating or cooling modes in various devices. Due to its wide range of temperature measurement from -30°C to+999°C and ease of operation, it can be used for building and repairing soldering stations.

Characteristics:

• Temperature range from -30°C to+999°C
• Temperature measurement accuracy - ±1°C
• Temperature sensor - K-type thermocouple
• Sensor error correction limits - from -10°C to+10°C
• Hysteresis range - from 1°C to 100°C
• Supply voltage - 12V/24V
• Power consumption - <3W
• One relay output
• Switching load - 250V 10A
• Display type - LED, combined
• Display size - 38x20mm
• Module size - 79x51x27mm
• Weight - 70g

After turning on the power, the display shows the temperature in real time. To program the modes, four clock buttons are used: "ENT", "SET", "+", "-".
"ENT" button: short press - memorize the set value; long press - turn on/off the module.
"SET" button: selection of F1, F2, F3, F4, F5 programming modes.
"+" button: increase of the set value.
Button "-": decreasing the set value.

Programming modes:
F1 - temperature selection
F2 - module operating mode selection: H - heating, C - cooling
F3 - hysteresis setting
F4 - thermocouple reading correction
F5 - temperature setting, upon reaching which a sound signal will sound.

Example of setting for heating.

In the boiler, it is necessary to maintain the water temperature at 80-90 ℃.
If the water temperature exceeds 90 ℃, then stop heating when the water cools down to 80°start heating.
Make settings as follows:
1.set the stop temperature to 90 ℃;
2.set the operating mode in heating mode H;
3.set hysteresis 10 ℃, means when the water temperature will reach +90 ℃, heating will stop and when the water is cooled by 10, the heater will turn on again.

Example of setting for cooling:

In the refrigerator, the temperature must be maintained at -5 ℃ ~ 0 ℃
When the temperature reaches -5 ℃, stop cooling, when the temperature rises to 0 ℃, start cooling again.
Make the settings as follows:
1 .set the stop temperature to -5 ℃;
2.set the operating mode to cooling mode C;
3.set the hysteresis to 5 ℃, means when the temperature reaches -5 ℃ refrigeration stops and when the temperature reaches 0 ℃, refrigeration starts again.