Natural elasticity and thermal conductivity combined with small thickness and high strength give minimal thermal resistance with reliable electrical insulation
Heat-generating electronic components are mounted without thermal paste, which ensures reliability and electrical safety and shortens assembly time
Thanks to fiberglass reinforcement the materials resist mechanical damage under strong compression between the flat surfaces of the case and heat sink – mounting pressure up to 40 MPa does not damage the material. The flexible, highly thermally conductive silicone base fills surface micro-irregularities
The materials are non-toxic, release no harmful substances during mounting and operation, and are not affected by PCB cleaning agents.
Specifications:
Thermal resistance: 0.4°C*sq.in/W
Electrical insulation: 10 kV/mm
Insulation resistance: 2.9 x 1015 Ohm/cm
Operating temperature : from - 60°C to +180°C
Thickness : 0.3 mm
Size: 18x22 mm
Hole diameter 4 mm
Attention! maximum thermal conductivity is reached a few hours after mounting, as the pad material gradually fills the surface micro-irregularities.
Only registered users can leave feedback and ask questions
The data presented in the product description are for reference only and may differ from those indicated by the manufacturer.
To carry out technical calculations and obtain the exact parameters of the goods, use the datasheets from the manufacturer's website.
If you need additional information, or you found an error in the description, or have other questions about this product, then our manager will help you: Ярослав
unknown