Tip insulator made of hard plastic, such as carbolite.
To install the lug on the wire, you must unscrew the knurled nut, this will open the radial hole. We pass the wire into the end of the hollow insulator so that it slightly comes out of the hole above under the insulator. Remove the insulation, tighten the nut - installation is over.
Only registered users can leave feedback and ask questions
The data presented in the product description are for reference only and may differ from those indicated by the manufacturer.
To carry out technical calculations and obtain the exact parameters of the goods, use the datasheets from the manufacturer's website.
If you need additional information, or you found an error in the description, or have other questions about this product, then our manager will help you: Евгений ЗП
unknown