Standard two-line character display. 8 characters per line. Pinout identical to Winstar, Cyrillic. Power 5V. Blue background. White characters. Backlight.
Standard two-line character display with 8 characters per line. White characters on a blue background. Has Cyrillic characters (Cyrillic) in the controller's character table.
The controller used is ks0066 , an equivalent of HD44780 and is a suitable replacement for it. Display supply voltage 5 V.
Pinout identical to displays by Winstar. The display backlight is already connected via a current-limiting resistor on the board to the display power pins. To set the character contrast, install a resistive divider (such as a trimmer or potentiometer) with its wiper to the Vo pin and the other ends to the display supply.
Display pinout:
Using the display:
A microcontroller or microprocessor is needed to display characters. Control is via a parallel interface consisting of: RS, R/W, E, DB0-DB7 (data lines) . See the datasheet for control details.
This module was tested on Arduino UNO with the standard library LiquidCrystal and its example sketches. It can display Latin characters and numbers. Open the standard example sketch HelloWorld from the LiquidCrystal folder. Connect the display to the Arduino pins as described in the sketch. In the line "lcd.begin(16, 2);" change 16 to 8, which is the number of characters per line. The line "lcd.print("hello, world!");" outputs "hello, world!" on the display.
This library does not support Cyrillic for several reasons, but it can output any character directly from the character generator table. This way Cyrillic text can be displayed character by character. There are two methods for this. First method: using the function "lcd.write();". To display a character from the table, just give its address in binary or hexadecimal. For example, to display the Cyrillic letter "De", look up its address in the table: HHHL for the upper 4 bits and LLLL for the lower. In binary this is 0b11100000 , in hexadecimal it is 0xE0. The result is "lcd.write(0b11100000);" or "lcd.write(0xE0);". Second method: using an escape sequence \x## in the line that prints the string via the function "lcd.print();" . As the ## we use the hexadecimal character code from the table. For example, the string "lcd.print("\xE0" "o" "\xBC");" will display "Home".
There are also third-party libraries, such as LiquidCrystalRus , that can "correctly" display Cyrillic characters from a string. Depending on the version ARDUINO IDE and its libraries works with varying success, often conflicting with the standard library.
Display character table:
Only registered users can leave feedback and ask questions
The data presented in the product description are for reference only and may differ from those indicated by the manufacturer.
To carry out technical calculations and obtain the exact parameters of the goods, use the datasheets from the manufacturer's website.
If you need additional information, or you found an error in the description, or have other questions about this product, then our manager will help you: Денис - Днепр
unknown