This set is recommended for use when repairing or replacing CCFL lamps with LED strips in monitors, TVs, laptops.
Each plate contains 60 LEDs. The LEDs are connected by clusters of 3 LEDs, which allows them to be cut to the desired length.
Lamp parameters:
Width:4mm
.
Height (with LEDs):2.65mm.
LED spacing:5.5mm.
Colorful temperature:5000-7000K.
Equipment:
-
LED lamp - 2 pcs;
-
Driver - 1 pc;
-
Driver cable - 1 pc.
No self-adhesive materials are applied.
Driver dimensions:70 x 20 x 10 (mm).
Supply voltage:10-30 V.
PWM - brightness control.
The kit uses a driver
DF6113according to the switching circuit ENA+DIMM inverted analog dimming. To connect to a constant full brightness, the ENA (enable) contact must have a high logic level (+ 5V), and the DIMM (dimming) must have a low logic level (connect to a minus or simply leave it unused).
For dimming (dimming), it is necessary to apply a high logic level to the ENA contact, and apply a PWM signal or an analog signal to the DIMM, taking into account that the dimming connection circuit is inverse (0-on, 5V-off).
For more details, see the datasheet for the microcircuit.
Typical driver circuit:
The brightness control is not completed.
Check if the connectors are connected correctly !!! The store is not responsible for the correct connection of the power poles from the driver to the monitor!And the design is such that they can be confused in color if you insert the connector on the other side. On the back of the driver board, the lettering of the pin assignment is painted with paint. 7 Check before cutting the wire!