DRV8825 stepper motor driver based on the TI DRV8825 chip.
Works with stepper motors from 8.2 to 45V and up to 1.5A per phase (up to 2.2A with forced air cooling). Adjustable output current, overload and overheat protection, six microstep modes: full step, half step, 1/4, 1/8, 1/16 and 1/32 step. Works with both 3.3 and 5 V logic.
It is pin-compatible with the A4988, but the DRV8825 board has its trimmer on the other side of the PCB, so be careful to orient the driver board correctly!
Main specifications:
Driver chip: DRV8825
Motor supply voltage: 8.2 - 45V
Rated motor current (adjustable) : 0 - 1.5 A
Maximum motor current (forced cooling): 2.2 A
Logic voltage: 2.5 - 5.25 V
Supported logic levels: 3.3 and 5 V
Microstepping: full, half, 1/4, 1/8, 1/16, 1/32
Control type: step-direction
Maximum step frequency: 250 kHz
Minimum pulse width: 1.9 µs
Overheat protection: yes
Overload protection: yes
Reverse polarity protection: no
Dimensions: 15x20x11 mm
Weight (without heat sink): 3g
Only registered users can leave feedback and ask questions
The data presented in the product description are for reference only and may differ from those indicated by the manufacturer.
To carry out technical calculations and obtain the exact parameters of the goods, use the datasheets from the manufacturer's website.
If you need additional information, or you found an error in the description, or have other questions about this product, then our manager will help you: Денис - Днепр
unknown