High-power step-down DC/DC converter with adjustable regulated output voltage and adjustable maximum current. Based on synchronous rectification using the LM25116 IC and two IRFB3607 MOSFETs.
Current and voltage are adjusted with trimmer resistors on the board. Output current can reach 20 A. The module has overcurrent, overheat and short-circuit protection.
Great for powering LEDs, building chargers, a simple adjustable converter, or a module for a lab power supply.
Main specifications:
Maximum output power: 300 W
Ripple: ± 50 mV
Voltage regulation: 0.5 %
Load adjustment: 2.5 %
Input voltage:6 - 40 V
Output voltage: 1.2 - 36 V
Maximum output current: 20 A
Efficiency: ≤95%
Overload protection: yes
Overheat protection: yes
Short-circuit protection: yes
Operating temperature range: -40 ... +85 °C
Dimensions module: 60x53x27 mm
Terminal block pinout:
IN+: "plus"input supply voltage
IN-: input supply "negative"
OUT+: "plus" output voltage
OUT-: output voltage "minus"
Adjustment:
CV:output voltage adjustment
CC:output current adjustment
When using this module, note some of its features:
If the heat sink heats up above 60 degrees, active cooling (a fan) must be installed, otherwise it may fail
The input/output voltage difference must be at least 2V. The output voltage cannot exceed the input voltage.
When using the converter, the input and output "negative" must be galvanically isolated (not connected), otherwise the current sense resistor will be "shorted" and the output current limit will not work. This can overload and damage the module.
Only registered users can leave feedback and ask questions
The data presented in the product description are for reference only and may differ from those indicated by the manufacturer.
To carry out technical calculations and obtain the exact parameters of the goods, use the datasheets from the manufacturer's website.
If you need additional information, or you found an error in the description, or have other questions about this product, then our manager will help you: Денис - Днепр
unknown