Inverter module board with PWM controller, MOSFET driver, feedback and frequency adjustment.
The generator is built on the SG3525 PWM controller. A trimmer on the board adjusts the frequency
Adjustable within 20-35 kHz. The MOSFET gate driver uses four bipolar transistors whose output can drive MOSFETs directly.
Board pinout:
Pin 1 - board power (12-24V)
Pin 2 - output 1
Pin 3 - board negative (ground)
Pin 4 - output 2
Pins 5 and 6 - output disable input (optocoupler)
Pin 7 - disable output
Pin 8 - IC input for output voltage regulation (feedback)
The disable input uses an optocoupler, which is convenient when isolation between the IC and the disable sensor is needed; the trigger current is about 5 mA. The optocoupler signal is amplified by an LM358 op-amp to the level required by the SG3525 output disable input.
Only registered users can leave feedback and ask questions
The data presented in the product description are for reference only and may differ from those indicated by the manufacturer.
To carry out technical calculations and obtain the exact parameters of the goods, use the datasheets from the manufacturer's website.
If you need additional information, or you found an error in the description, or have other questions about this product, then our manager will help you: Денис - Днепр
unknown