1. Product introduction:
The water flow sensor is mainly composed of a plastic valve body, a water flow rotor assembly and a Hall sensor.
It is installed at the water inlet end of the water heater and is used to detect the water flow. When the water passes through the water flow rotor assembly,
The magnetic rotor rotates and the speed changes with the flow rate, and the Hall sensor outputs corresponding pulses
The signal is fed back to the controller, and the controller judges the size of the water flow and regulates it
Precautions for use:
Severe impact and erosion of chemical substances are strictly prohibited.
Throwing or bumping is strictly prohibited.
Install vertically with an inclination of no more than 5 degrees.
Medium temperature should not exceed 120°C.
2. Output waveform diagram: square wave NPN pulse signal
3. Outlet mode:
-
Red IN connected to the positive pole
-
Yellow OUT signal output line
-
Black GND connected to the negative pole
YF-S201 Frequency: F=7.5*Q(L/Min) Error: ±2% Voltage: 3.5-24VDC, current cannot exceed 10mA, output 450 pulses after one liter of water flows
That is, frequency calculation = constant 7.5 * unit flow (L/min) * time (seconds)
Flow range: 1-30L/min
4. Technical parameters
Scope of application:
Suitable for water heaters, credit card machines, automatic water vending machines, and other flow metering equipment!
1. Minimum rated working voltage DC4.5 5V-24V
2. Maximum working current 15 mA(DC 5V)
3. Working voltage range DC 5~18 V
4. Load capacity ≤10 mA(DC 5V)
5. Operating temperature range ≤80℃
6. Use humidity range 35%~90%RH (without frost)
7. Allowable withstand voltage Water pressure below 1.75Mpa
8. Storage temperature -25~+80℃
9. Save humidity 25%~95%RH