Tool for desoldering soldered joints.
During operation, periodically remove the piston, clean solder and flux residues from the inner cylinder cavity, and lubricate the piston O-ring with grease.
When replacing tip the thread must be wrapped with FUM plumbing tape to prevent air from being drawn in through the thread.
Attention! do not leave the desoldering pump switched on for long! with prolonged heating without use, the seal between the pump section and the heater overheats, the rubber ring dries out and the joint loses its tightness. The gasket can be restored with high-temperature automotive silicone sealant, or formed entirely from such sealant.
Only registered users can leave feedback and ask questions
The data presented in the product description are for reference only and may differ from those indicated by the manufacturer.
To carry out technical calculations and obtain the exact parameters of the goods, use the datasheets from the manufacturer's website.
If you need additional information, or you found an error in the description, or have other questions about this product, then our manager will help you: Ярослав
unknown