Soldering iron with ceramic heater with built-in thermocouple, supply voltage 24V, power 50W.
5-pin connector, i.e. soldering iron without motion sensor.
Sting - cone with an end face of 0.4 mm, durable, chrome-plated.
The design of the heater is a ceramic rod wound with a thin nichrome wire, enclosed in a shell - a ceramic tube. There is also a thermocouple under the shell. The ceramic sheath protects the nichrome heater from rapid burnout, improves heat transfer, and also insulates the tip from supply voltage breakdown.
It is also possible to use with similar soldering stations from other manufacturers, designed to work with a soldering iron, the heater of which has a built-in thermocouple as a temperature sensor. You only need to replace the connector.
For example, this soldering iron is suitable for Lukey-702 and Lukey-852D+FAN stations, if you change
connectoror connect via
adapter.
Parameters
heater: for a working element, the resistance between the heater terminals is 16-17 Ohm, the resistance between the thermocouple terminals is about 0.5 Ohm.
To connect the soldering iron to non-original control units (homemade or from other manufacturers), you can use the following mating connector parts:
for installation on the device body