ЧП Ворон. Электронные компоненты и радиомонтажное оборудование. Микросхемы, транзисторы, реле, резисторы, конденсаторы, паяльное оборудование, припой.
Корзина пуста!
ВХОД ДЛЯ КЛИЕНТОВ

Забыли пароль?
Зарегистрироваться

Шановні клієнти інтернет-магазину!

  У зв'язку зі святкуванням Нового Року ми працюємо за наступним графіком:
• з 31.12.24(Вт) по 02.01.25(Чт) не працюємо
• з 03.01.25(Пт) працюємо в звичайному режимі.

  Інтерет-магазин приймає замовлення цілодобово 24/7 !



Поиск:

Enter a search string or click on the microphone icon and begin speaking.

×
История запросов
ваша история поиска пуста
Whole catalog Development toolsModulesCommunication modules
Код товара:
036254

WiFi module ESP8266 ESP-01S 1Mb

Wi-Fi module based on ESP8266
It can also be used as a separate microcontroller for a smart home.
WiFi module ESP8266 ESP-01S 1Mb
In stock
75,60 UAH × = 75,60 UAH
from 1 pc : 75,60 UAH
from 5 pcs : 71,82 UAH ( -5,0%)
from 20 pcs : 64,26 UAH ( -15,0%)

Current balances:

Магазин-Днепр
112 pcs
For Online Orders
112 pcs

Изображение товара

Микроконтроллер с WiFi ESP8266 ESP32 (реле, датчик DHT22, ESP камера)

Product description format_size zoom_out zoom_in

Wi-Fi module ESP8266 version ESP-01S based on the ESP8266EX chip. Has a built-in TCP/IP protocol stack and can be controlled by AT commands. Ideal for use in smart home systems in devices such as: smart plugs, all kinds of sensors, IP cameras, wearable electronics, etc.
 

Possible modes of operation:

  • as a bridge between the UART and WIFI interfaces, while the ESP8266-01S is connected to the system from a microcontroller (Arduino or other) and sends AT commands, providing control of other Wi-Fi devices
  • used independently without a controller, the ESP8266-01S module performs the functions of a control microcontroller

Main characteristics:

  • Supply voltage: 3V ~ 3.6V
  • Maximum working current: 220mA
  • Wireless support: 802.11 b/g/n
  • Working Frequency: 2.4GHz
  • Modes: P2P (client), soft-AP (access point)
  • Built-in TCP/IP stack
  • Standby consumption up to 1.0 mW (DTIM3)
  • Time to wake up and send packets: up to 22 ms
  • Number of GPIOs: 2
  • Protocol support: SDIO 2.0, SPI, UART
  • Flash memory: 1024 kb
  • Output power in 802.11b mode:+19.5dBm
  • Dimensions: 24.8 x 14.3 x 8 mm

Pin assignment:

  • GND: "-" module power supply
  • GPIO2: (Digital I/O programmable)
  • GPIO0: (Digital I/O programmable, also used for boot modes)
  • RX: UART receive
  • TX: UART transmission
  • CH_PD: (power on/off, must be brought to 3.3V directly or through a resistor)
  • RST: reset, must be pulled to 3.3V
  • VCC: "3.3V" power supply of the module

Leave your feedback or ask a question

Only this product is discussed here. Off topic comments will be deleted! Please follow the Commenting Rules.

The data presented in the product description are for reference only and may differ from those indicated by the manufacturer.
To carry out technical calculations and obtain the exact parameters of the goods, use the datasheets from the manufacturer's website.

If you need additional information, or you found an error in the description, or have other questions about this product, then our manager will help you: Денис - Днепр unknown

Buy with this product: Посмотреть больше…