ЧП Ворон. Электронные компоненты и радиомонтажное оборудование. Микросхемы, транзисторы, реле, резисторы, конденсаторы, паяльное оборудование, припой.
Cart is empty!
CUSTOMER LOGIN
Search:

Enter a search string or click on the microphone icon and begin speaking.

×
Query history
your search history is empty
Whole catalog ↠ Radio constructors (full set of parts)
Product code:
045718

Radio constructor Amplifier 1x140W on TDA7293 K207.1

DIY audio amplifier board kit
Radio constructor Amplifier 1x140W on TDA7293 K207.1
Manufacturer: RADIO-KIT
In stock
324,20 UAH × = 324,20 UAH
from 1 pc : — 324,20 UAH

Current balances: 10 pcs


Technical documentation

K-207K-207 (226Kb)

Product picture

Product description format_size zoom_out zoom_in

  This kit allows you to assemble a simple and powerful monophonic low-frequency amplifier with small dimensions, a minimum number of elements, a wide range of supply voltages and load resistances.
 

Specifications:

K/M-207.1, TDA7293
  • Supply voltage (bipolar supply) . .±12 - ±50V
  • Frequency range . . . . . . . . . . . . . . . . . . 40Hz - 20kHz
  • Maximum output power:
  • Uсс. ±45V, Rn 8 Ohm. . . . . . . . . . . . . . . 140W
  • Uсс. ±30V, Rn 4 Ohm. . . . . . . . . . . . . . . 110W
  • Coef. harmonics:
  • Pout=5W, F=1kHz. . . . . . . . . . . . . . . 0.005%
  • Pout=0.1...50W, F=20Hz...20kHz . . . . <0.1%
  • Rated input voltage . . . . . . . . . . . .700mV
Attention!
The amplifier uses a bipolar power supply.

Schematic diagram

  In a typical switching circuit (TDA7294), the ULF develops 70 W of sinusoidal power at a load of 4\6\8 Ohms at supply voltages of ±27V, ±31V, ±35V, respectively. Musical power in this case is 100 watts.
  To power the device, you should use a power source with a power not less than the rated power of the amplifier. Additionally, you need to install filtering power supply capacitors with a capacity of at least 4700 μF (recommended 10000 μF) in each source arm. If a switching power supply is used, it must be remembered that the peak current consumption of the amplifier can be several times higher than the average.
WARNING!
The U1 chip must be installed on a heat sink with an area of ​​at least 600 sq.cm. using heat-conducting paste, given that its body is connected to the negative terminal of the power source.
 

Only registered users can leave feedback and ask questions

The data presented in the product description are for reference only and may differ from those indicated by the manufacturer.
To carry out technical calculations and obtain the exact parameters of the goods, use the datasheets from the manufacturer's website.

If you need additional information, or you found an error in the description, or have other questions about this product, then our manager will help you: Денис - Днепр unknown

Buy with this product: View more…

Последние просмотренные товары Посмотреть Последние...