One-component structural adhesive based on methacrylate.
Main purpose - bonding rigid plastics such as ABS, PC, PVC, PMMA, fiberglass laminate and other similar non-metallic materials. Also has good adhesion to metals, glass, crystal, quartz, jewelry, etc.
Anaerobic, impact-resistant.
Gel-like, easy to apply.
The initial cure time of the adhesive at 25°C is no more than 10 min. The cure rate can be increased with activator K-7246; the cure time will then be no more than 5 minutes. Full cure takes place within 24 hours, when nominal strength is reached.
The bond line thickness must not exceed 0.25 mm.
Specifications:
-
name: K-0306 Anaerobic structural adhesive
-
main ingredient: methacrylate
-
appearance: yellowish viscous liquid
-
density: 1.06 g / cm³
-
viscosity: 1000 ~ 3000 mPas
-
fire point: > 108 °C
-
shear strength: ≥12 MPa
-
operating temperature: -54 ~ 120 ° C
-
curing time (at 25 °C): ≤10 min (initial cure), 24 h (full cure)
-
gap fill, max : 0.25mm
Application recommendations:
1) Clean and degrease the surfaces to be bonded.
2) Apply the adhesive to the surfaces and press them together. When used without activator K-7246, the initial cure time should be 10 minutes.
3) When used with activator K-7246, the adhesive can be applied to one of the bonding surfaces and the activator to the other; the compound can then cure within 1 ~ 5 minutes. If the bond line is thicker (up to 0.25 mm) or a faster cure is required, activator K-7246 should be applied to both surfaces. The parts must be assembled immediately.
Remember that the bond reaches full strength after 24 hours!