For soldering irons of the 907, 900M, 900L, 908, 913, 914 series.Used in soldering stations of many manufacturers
Ceramic heating element 1321 with built-in thermistor as temperature sensor.
PTC ceramic, not a nichrome coil in a ceramic sheath.
Rated supply voltage - 24 V.
Rated power - 55 W.
In some soldering station models, the heater supply voltage is higher and, accordingly, so is the power drawn. With properly implemented PID temperature control of the soldering iron, this heater tolerates exceeding its rated power well, but the quality of the soldering tips used must be monitored. Cheap tips with reduced thermal conductivity or out-of-spec mounting dimensions significantly shorten the life of the heating element.
The key difference of this heating element is the resistive temperature sensor. It must not be replaced with a similar heater with a nichrome coil and thermocouple!
To avoid confusion, pay attention to the external distinguishing features of the original heater:
-
there is a longitudinal groove along the heater formed in manufacturing;
-
the outer end of the heater is a flat disc slightly smaller in diameter than the heater itself, like a step (on nichrome heaters the end cap is mushroom-shaped or just sealed with ceramic paste, and sometimes falls out).
In a working element, the resistance between the heater leads is about 3-4 Ohm, and the resistance between the temperature sensor leads is about 40-60 Ohm.
Inspect heaters carefully when buying; beware of counterfeits.
Packaging: blister with insert (protects against damage during transport).
All heating elements are tested before sale - visual inspection and checking heater and sensor resistance.
The warranty does not cover heating elements.