Silicone sealant adhesive Kafuter K-704NB RTV 45g BLACK
One-component silicone sealant, methanol-free.
The adhesive has excellent adhesion to metals and most plastics, and after curing shows outstanding resistance to thermal cycling (-60~200 ℃ ) .
It features excellent adhesion, good resistance to vibration, shock and deformation; non-corrosive action, low volatility and excellent electrical insulation properties; it is resistant to UV radiation and moisture, and has good anti-aging properties, good repairability and excellent weather resistance.
Product applications:
1. Sealing and bonding in the automotive, lighting and other industries.
2. Fixing and sealing of electronic components.
Packaging: 45 gram tube.
Specifications:
product type: room temperature curing silicone rubber (demethanol)
color: black
operating temperature range: from -60C to +200°C.
density (g/cm³) 1.3 - 1.5
drying time: (25°) ≤25 min (full cure in 24 hours)
dielectric constant,kv/mm: ≥15
hardness (Shore A): 20-40;
tensile strength ( MPa ) ≥1.2
elongation at break ( % ) ≥300
shear strength ( MPa ) ≥1.2
What to choose and when?
1) Choose K-704B if you need to seal a thin seam, fill a joint in a housing, bond an LED profile, or apply the adhesive so that it fills small voids under a part by itself.
2) Choose K-704NB if your task is — to spot-fix heavy leaded components on a board (large capacitors, inductors), bond a vertical joint, apply a thick damping layer, or repair a part without the risk of the adhesive flowing deep into the device.
Usage guidelines
Single-component silicone compounds cure by reacting with moisture in the air. They cure well at room temperature at relative humidity from 30% to 80%. About 90% of their physical property values is reached within 24 to 72 hours. Curing can be accelerated by slight heating, not above 60 °C.
Silicone sealants must be stored in sealed containers, with no contact with air.
When working with sealant, the time to apply the silicone is limited, usually from a few minutes to an hour before a surface skin forms that impairs adhesion.
One-part compound should not be used in enclosed volumes or applied in a thick layer, as curing then takes much longer.
Only registered users can leave feedback and ask questions
The data presented in the product description are for reference only and may differ from those indicated by the manufacturer.
To carry out technical calculations and obtain the exact parameters of the goods, use the datasheets from the manufacturer's website.
If you need additional information, or you found an error in the description, or have other questions about this product, then our manager will help you: Ярослав
unknown