One-component, acid-free, RTV-type silicone adhesive, general purpose.
Viscous, thixotropic mass of black color.
It is chemically neutral, does not contain acids, and therefore does not cause corrosion of the bonded surfaces. No pungent odor.
Good adhesion to metals, plastics, glass, ceramics, wood.
Provides dielectric insulation and prevents aggressive environmental influences.
High temperature, retains its mechanical and dielectric properties in the temperature range from -60C to +260°C.
Not flammable. Water and oil resistant.
Good dielectric properties.
Recommended for sealing submarine cables, encapsulating various sensors, sealing winding products (ignition coils, solenoids, transformers), as well as for insulating electronic components on boards.
Maintains elasticity, high adhesion and water resistance at low and high temperatures. Accordingly, it is recommended for use in various climate control equipment (air conditioners, refrigerators, freezers, ventilation systems, water heaters), as well as in the automotive industry (gluing headlights, sealing various elements).
Packaging: 100 gram tube.
Characteristics:
|
name
|
K-5912
|
|
color
|
black
|
|
consistency
|
pasty
|
|
density,g/cm3
|
1,2 ~ 1,4
|
|
initial cure time
|
≤ 30 minutes (at 25°C) |
|
tensile strength, MPa
|
1,5
|
|
extension,%
|
250 ~ 350
|
|
shear strength
|
≥1.0 MPa
|
|
Shore A hardness
|
35 ~ 45
|
|
operating temperature range
|
-60 ~ 260 °C
|
|
dand electric strength
|
18 kV/mm
|
|
dielectric constant
|
2.8 (at 60Hz)
|
|
aboutvolume resistance
|
1×10 16Ohm*cm
|
Recommendations for use:
Curing of one-component silicone compounds occurs due to interaction with moisture contained in the air. Cures well at room temperature in the relative humidity range from 30% to 80%. About 90% of their physical properties are achieved within 24 to 72 hours. You can speed up the curing of the composition with slight heating, not higher than 60 °C.
Silicone sealants should be stored in airtight containers, avoiding contact with air.
When working with adhesive-sealant, the time for applying the silicone mass is limited. Typically this period ranges from several minutes to one hour before the formation of a surface film that impairs adhesion.
It is not advisable to use a one-component compound in confined spaces or apply it in a thick layer, because in this case, the curing period increases significantly.